Skip to main content
Electrolux | Help and Support

Hot plate switches itself off / beeps

 

 

If the hot plate switches itself off / beeps, refer to the suggestions below for step by step instructions.

Possible causes: Solutions:
Liquid is spilt on the control panel. Wipe down the control panel with a damp cloth, then dry the surface with a towel.
No heat setting is selected. If you switch on the hot plate without selecting the heat setting, the hot plate will switch itself off after approximately 10 seconds.
The control panel is covered. If a cloth or other material covers the control panel (fully or partially), an acoustic signal will sound. Remove the object from the surface of the control panel.
Automatic switch off.

If the hot plate was left on for too long, it will switch itself off for safety reasons, in order to prevent the pots or the saucepans from boiling dry.

The procedure depends on the selected setting. Refer to the user manual, if applicable. 

Note: The time before the plate is switched off depends on the power setting selected. See the user manual. 


To help you determine the exact nature of the problem, we recommend a visit by one of our authorized engineers to check the appliance and fix the problem.

When contacting us, please have the following information to hand. You will find this information on the manufacturer’s data plate:

Data plate with model number, product number/PNC, ELC and serial number:

modelnoexplanation1.gif
  1. Model number
  2. Product number (PNC)
  3. ELC number
  4. Serial number

Where will I find the data plate on my product?   

NOTE: Depending on the problem, you may be charged for a service visit by an engineer, even during the warranty period.

Warning: We do not recommend using the product until the problem has been completely fixed. Unplug the product and do not plug it in again until you are certain that it is OK to do so.